Fall fishing on the course is considered difficult. Cast with a float snap with the free sailing now rarely catch a big fish. The reason is very simple, the lure gets in field of vision fish for a very short time.
Overfed during the summer the fish are not chasing food. Fishing is complicated, and when uneven for added water turbidity after rains. The fish in these conditions only by chance missing something that passes by, or rather, swims into the mouth or resting on the bottom. Also fishing with the traditional clearomizer snap in some cases may be impossible due to the fact that we have to apply a thin fishing line, otherwise easy snap-on makes the surface of the water. If weight snap, bite become invisible. To find the right balance in the tackle is very difficult, and sometimes impossible.
Go to the bottom gear may interfere with the bottom topography is uneven within and cautious bite. By analogy with the spring fishing, are presented two variants of gear — plug and short the bottom snap. Plug the blue all just, as such terms are snap, the designs of which are based on the use of floats, called “flat”. Depending on the strength of the flow, from the uniformity of the jet, the depth and distance of fishing, from the fishing activity and the transaction type, select the snap-in varying designs, with a particular float. Largely the choice of float is determined by the angler, and due to the information received from the other anglers.
Combines flat floats that their design provides a maximum stability of the float on the current. For this, the drag of the float is minimized, and the mounting scheme on the line redistributes the impact of flow on the float so that it occupies a vertical position in the data stream, the depth and design the fixture as a whole. The stronger the current, the snap-floats in General more efficient.
The most common design is a right disc made of plastic or wood. In addition to the main keel, the float features a wire support that is designed to eliminate Solisti fishing line for the bottom of the keel and make the entire structure more rigid. The antenna can be as ordinary float, but it is better to use a flat and wide of the antenna. Since the body of the float is in the operating state, is oriented parallel to the shore, and the flat antenna always very well visible. The top of the remote console of a float through which fishing line can be in different versions. In the first embodiment, the fishing line passes through the carrying ring. A ring related with the console of the body of the float to tucking the console you can adjust the angle of force application from the side of the rod and the side of the sinkers, that is, to adjust the vertical position of the float in the water depending on current and depth. A more progressive replacement ring on the clasp. The fastener is formed by bending the tip console. On a folded piece of hard wearing sleeve for the fishing line, it is up to three inches. Shifting sleeve in either direction, adjust the position of the float in the water. If the stiffness of the wire in the console is sufficient, you can abandon the zipper and use only the sleeve.
Rigging consists of a main sinkers in the form of olives and a few pellets. Such a design is good when caught in the wiring with the slow sailing snap and hold the snap point of fishing, and the bait does not touch the bottom. This technique is common wiring while catching active fish in small streams, in areas with smooth flow.
In that case, if you deliberately catch from the bottom, reduce all weights to a single point. Distance from the sinker to the hook varies from 20 centimeters to meters, which depends on the bottom topography and the activity of biting. If the bottom is smooth and clean, it is best to make the leash longer. The descent is measured so that the combined sinker was in one to five centimeters above the bottom. But can this snap-in to use as a “poludecu” then was shifted to olive and put them on the bottom. Use this fishing technique is most often in cases where strong emotion on the water and when you catch a big fish on a bulk bait. But under the condition: for smooth, that is, without strong turbulence and frequent changes force and direction.
A somewhat different type of fishing practiced in cases where the current is strong, but depth is one to two meters, and sometimes less, and the fish are very cautious. Use at this depth heavy duty disc floats is not effective due to the lower sensitivity. Besides, at shallow depth, strong current becomes unstable, turbulent and equipment with disc float starts to “walk”. Big fish don’t like it. In such cases, well-behaved snap with floats, whose body, in the form of large drops or a few unusual shapes, shown in the photo. The capacity of such floats usually from three to eight grams.
The most common designs all ogruzka distributed into 5-6 parts on a piece of fishing line with a length of two feet. The upper sinker may be just 10-20 cm below the float. This scheme is almost fully consistent with the structure of “falling down” snap-in for catching the luffing rod in stagnant water.
There is some difficulty in the technique of fishing with this tooling. The fact that the definition of working descent becomes difficult due to the fact that the float is held in place and hollow out the line snap. To approximate the descent, you need to measure using depth of sinkers and set the descent so that the distance between the sinker and the float was equal to the measured depth. Then have a descent to gradually adjust until until the start of the bite. It should be noted that if the capacity of the float is small and the current is strong, there are cases when descent may exceed a depth of one and a half times two. In such cases, it is worth pondering, where does the plume from the bait. And in fact, it may happen that the bait will come out for a spot of bait and the bites will not.
Very often the technique of fishing with plug in for cold water fishing is to bottom snap. Bait heavy on the snap of the plug is placed on the bottom and waiting for fish to bite. The plug in this case is poludenko. Here the question arises, is it worth it to “suffer” with plug, if there is, for example, poledance?
Poledance as tackle and method of fishing using float rod, is a hybrid with a float rod and a donkey. With the market it combines that sinker and a hook with bait on the long line are always at the bottom. From float rods left set of snap-in float. The float is not in the water, and over its surface. In most cases, the bait and a few lower weights put on the bottom. When fishing it is essential to achieve such status snap when the bait is at the bottom, and the weight hanging on the line of the float balances the force of the water pressure on the line. If you change the place of fishing, and the new place for a stronger or more depth, then move the float to the rod. Bites are marked by tremor, twitching of the float or line tension. Traditionally, poledance use floats with one attachment point and, as a rule, elongated. To increase the useful angle on the line below the float to secure additional BB’s.
Poledance effective in strong currents in the muddy water, when used as a bulk bait for larger fish. The main drawback is that there may not be enough sensitivity snap during a careful bite.
Plug allows you not only to keep the lure at the selected point of fishing, but also to use more sensitive equipment. And sensitivity is achieved by adjusting the balance of the snap. You can always switch to a different type of transaction, for example, to put a snap in a free swim or use the transaction priderzhki sailing.
© 2016, micetimes.asia. All rights reserved